Re: help needed to troubleshoot

Tubes Asylum

Questions about tubes and gear that glows. FAQ

In Reply to: help needed to troubleshoot posted by Patster on September 19, 2006 at 19:06:57:

I am guessing that, during installation of the tube socket, solder bled into the gap intended for the tube pin. A drill bit, slightly smaller then the diameter of the tube's pin, may be used to drill out the hole.
Desoldering the area would probably be more difficult.
Richard

This post is made possible by the generous support of people like you and our sponsors:

Signature Sound

[ Signature Sound Lounge ]

Follow Ups Full Thread

Topic - help needed to troubleshoot - Patster 19:06:57 09/19/06 (4)

Re: help needed to troubleshoot - akanalog@yahoo.com 08:20:23 09/21/06 (0)

What valve is it? - Olly 00:16:45 09/20/06 (2)

Re: What valve is it? - Patster 06:15:09 09/20/06 (1)

Re: What valve is it? - Olly 17:30:02 09/20/06 (0)

Follow Ups

Re: help needed to troubleshoot - akanalog@yahoo.com 08:20:23 09/21/06 (0)

You can not post to an archived thread.