|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
|
|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
I am going to be bi-amping my system. I will be using 2 stereo amplifiers to accomplish this. I will need to split the pre-amp output so I can plug into the L + R input on each amp. I was thinking of using 2 pieces of 8451, soldering one connector to an end of each wire (at this point I will have 2 wires each with a connector on one end). On the other end of the wires I was thinking I would solder both wires to one connector. Is this the better method or should I just use a Y cable at the amp end and be done with it?
This post is made possible by the generous support of people like you and our sponsors:
Topic - DIY Belden 8451 interconnect / bi-amp - KWILLIS 04:27:13 11/02/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
